General Specifications per Brochure

Bar Size Capacity:                         3mm (.118") - 25.4mm (1")
Bar Length Capacity:                       12'
Maximum Bar Length:                        12' 5"
Minimum Bar Length:                        63"
Magazine Capacity:                         10.7 Linear Inches
Maximum Remnant Length:                    13"
Operating Voltage:                         230V AC 3 Phase (400V available)
Control Voltage:                           24 Volts DC
Total Power Required:                      2.5 kVA/1.8 KW
Compressed Air Required:                   90 psi, 1 cfm
Guide Channel Oil:                         CKB100, Quantity 5 Gals. (Not

                                          Incl.)

Feeding Speed:                             24"/sec max. (adjustable)
Facing Accuracy:                           +/- .020"
Bar Change Time:                           28 seconds for 12' bar
Bar Straightness Required:                 .007"/foot
Bar Feeder Shipping Weight:                1700 lbs.
Color:                                     RAL 5002 Blue, RAL 7035 Light Gray

Standard Equipment Includes:
Custom Electrical Cable Package & Interface Kit
Remnant Retract
Synchronization Device
Bushing Device
Guide Channel Set includes 1 bar pusher,
1 nose, 1 rotating tip, 1 collet

Options (prices subject to change without notice)

Accessories                                                       

Anti Vibration Device                                             $1,990
Category III interface (Dual Channel Safety Circuit Protection)   $1,490
Special adaptation kit (Required for some lathes)                 $1,990
                                                                  
Options                                                           

Additional guide channel                                          $2,000
Spindle liner                                                     $350
Additional collet (standard OD threaded collet) (D < 20mm)        $80
                                                                  
Installation                                                      

Installation in USA, Canada and Mexico                            $3,100
Includes labor, travel expenses and 12 month warranty

Important Notes:
Bar Feeder installation does not include lathe-side software or hardware for
magazine bar feeder interface. This interface must be supplied and installed
by the lathe OEM or Distributor, prior to bar feeder installation. Maximum
Bar diameters are for front ejection of the remnant. For remnant retraction,
maximum diameters are slightly less. Bar straightness, proper guide channel
selection, correct alignment and anchoring of bar feeder will ensure optimum
performance at maximum rpm.

      RETURN to our home page