Click on picture below for larger version

General Specifications As Per Brochure

Max. Pressure:                           140 Bar
                                         2000 PSI
Coolant Volume:                          Fixed Rate System
                                         20 Liters / Minute
                                         5 GPM
Tank:                                    380 Liter / 100 Gallon
Filtration:                              Single Bag
Outlets                                  5


Standard Configuration:
The ChipBLASTER J-20 is fed by a transfer pump that draws from the machine

tool sump, through the filter vessel to the integral 380 liter (100 gal) tank. 

When the machine tool calls for coolant, the filter pump(s) draws the coolant

from the ChipBLASTER tank and pumps through the post (safety) filter to the

inlet of the positive displacement pump. The coolant then flows at high

pressure through a series of distribution and safety valves and on to the

machine tool.

M Code Requirement:
  1 "M" Code Controlled Signal is Required for Activation/Deactivation of the

  Chip Blaster
  2" M" Code Controlled Signals are Required to Operate the Two Outlets
  3" M" Code Controlled Signals are Required to Operate the Three Outlets
  4" M" Code Controlled Signals are Required to Operate the Four Outlets
  5" M" Code Controlled Signals are Required to Operate the Five Outlets
  A 24 VDC,110 VAC or 240 VAC Signal is Acceptable
*Latching "M" codes are standard, If your machine uses pulsed "M" codes,

please contact ChipBLASTER

Required Electrical Power:
  28 amps, 230 VAC, 3 Phase, 60 Hz
  14 amps, 460 VAC, 3 Phase, 60 Hz
  18 amps, 400 VAC, 3 Phase, 50 Hz

Ideal for Machine Tools Up to 10 Kw (15 HP) including Swiss

See brochure for more details and options

RETURN to listing display       RETURN to our home page