GENERAL SPECIFICATIONS AS PER BROCHURE

Bar Capacity:                                   1/16" - 1 5/8"
Maximum Bar Length:                             12'
Motor:                                          1 hp / 1,725 rpm
Electrics:                                      208/220/440 3 phase
Overall Length:                                 17'
Pump Motor:                                     1 hp
                                                220/440 volts/3phase
Machine Features:
   (3) Feed Tubes (customer to select sizes)
   Engineered for Swiss type CNC screw machines & small headstock lathes
   Feed tube change-over in 5 minuts
   Standard Z-axis capability
   Positive, pusher retention system
   Heavy duty construction for max rigidity & vibration prevention
   Unique swing-out mechanism
   Removable pendant for convenient operator control
   Hydraulic system requires 15 gallons of Pennzoil AW-100 hydraulic oil
     or equipment (supplied by customer)

Pries subject to change without notice ***

Additional feed tubes (available in 1/8" increments from 1/4" - 1 5/8"
   1/4",5/16",3/8",1/2",5/8",3/4",7/8",1",1-1/16",1-1/8"
   1-1/4",1-3/8",1-1/2",1-5/8"............................$1280.00 each
   1/8" feed tube kit.....................................$2,340.00 each
Optional spindle liners (each spindle liner size is priced as follows):
   ** note:  prices based onlathe draw tube i.d., not stock size
   1/4" thru 1-5/8".......................................$545.00 each
   ** note:  all bar stock must have a 30 degree chamfer cut on the pusher
             to achieve the highest performance.
Optional Step Down Transformer:

   for lathe applications that run on 440 Volts:..........$POR  

Optional custom electrical cable package with plugs:
   required if oem interface includes special plugs instead of terminal
     strip................................................$375.00 each
Optional front mounted safety switch:
   for use on swiss screw machine applications............$570.00 each
Electrical lathe interface:
   lathe must have programmable open & close of chuck and an appropriate
   interface provided by the lathe manufacturer.
Installation..............................................$2,800.00
   Includes:  Set-up and leveling of the bar feeder, alignment with lathe
              spindle and bolting to floor (bolts included), electrical
              connection to lathe, (interface supplied by builder), training
              and run-off of the bar feeder.  proper training and run-off
              depend on the lathe being operational, tooled & programmed, as
              well as stock & machine operator being available.
   Note:  Additional time, travel & expenses caused by customer, dealer or OEM
          delays will be billed at $120/hour on site, $60/hr travel plus
          expenses.

      RETURN to our home page