Click on picture below for larger version

General Specifications from Brochure

Features:                                 Single tube
                                          Muzzle-loaded design
Capacity:                                 2 1/2" maximum
Length:                                   12'
Interchangeable feed tubes
   = Three (3) feed tubes of customer selected sizes are included

Pump Motor:                               1HP, 220/440 volt, 3 Phase
Overall Length:                           18' (12' capacity model)
                                          12' ( 6' capacity model)
Weight:                                   1700 lbs.


*** Prices subject to change without notice ***

Additional Feed Tubes - available in 1/4" increments from 2-3/4" and priced as

follows:

    1/4",5/16",3/8",1/8",5/8",3/4",7/8",1",1-1/16",1-1/8"
    1-1/4",1-3/8",1-1/2",1-5/8"                               $1300.00 each

    1-3/4",2",2-1/4",2-1/2"                                   $1410.00 each

Optional Spindle Liners - Each spindle liner size is priced as follows:
NOTE:  Prices based on Lathe Draw tube I.D., not stock size.
    1/4" thru 1-1/8"                                          $570.00 each
    2-1/4" thru 2-5/8"                                        $570.00 each
    2-3/4" thru 3-1/8"                                        $570.00 each
    3-1/4" thru 4-1/8"                                        $775.00 each
    4-1/4" thru 5-1/8"                                        P.O.R.
    5-1/4" thru 6-1/8"                                        P.O.R.

For lathes with spindle bore to 3-1/8" that require 
a spindle adapter add                                         P.O.R
For lathes with spindle bore over 3-1/8" adapters:            quoted per order

Optional Standard Rhinobar Customer Electrical Cable Package 
    with plugs                                                $375.00
   (Required if OEM Interface includes special plugs instead of terminal

strip.)

NOTE:  All bar stock must have a 30 degree chamfer cut on the pusher end to

achieve the highest performance.

Warranty - One year, parts and workmanship

Installation by Lexair Personnel                              $2,800.00
    The standard installation includes set-up and leveling of the bar feeder,

alignment with lathe spindle
and bolting to floor (bolts included), electrical connection to lathe,

(interface supplied by builder), training and run-off of the bar feeder.

Proper training and run-off depend on the lathe being operational, tooled and

programmed, as well as stock and machine operator being available.

NOTE: Additional time, travel and expenses caused by customer, dealer or OEM

delays will be billed at $120.00 per hour on site, $60.00 per hour travel plus

expenses.

RETURN to listing display       RETURN to our home page