Serial No. L-84
          New - 1989
          
          SPECIFICATIONS:
          Marking Force.......................700 lbf to 5,000 lbf (317.5 to 2,268 kgf)
          Cross Slide.....................................0.5" to 6" (12.7 to 152.4 mm)
          Ram Stroke.....................................0.125" to 1" (3.18 to 25.4 mm)
          Throat Height
          Ram Down/Head Down.............................................0.5" (12.7 mm)
          Ram Up/Head Up.................................................18" (457.2 mm)
          Throat Width................................13.5" (342.9 mm) Between Uprights
          Marking Table Size......................24" Wide x 8" Deep (609.6 x 203.2 mm)
          Marking Table Bolt Pattern.........................4" x 6" (101.6 x 152.4 mm)
          Cycle Rate..............43 CPM at a 1" (25.4 mm) Stroke & 700 lbf (317.5 kgf)
                             35 CPM at a 1" (25.4 mm) Stroke & 5,000 lbf (2,267.96 kgf)
          Electrical...........................................220/440 VAC, 3 PH, 60 Hz
          Motor.....................................1.5 HP, 1,725 RPM (1.52 HP, Metric)
          Pump.......................................................1.5 GPM (5.68 LPM)
          Fluid Reservoir........................................5 Gallon (18.93 Liter)
          
          Sequence of Operation:
          The desired legend, composed of both steel type and logodies, is set in the
          roll style type holders which are mounted in two Versa-dex carriages. These
          carriages are positioned on a special dove-tail mounting bar corresponding to
          the diameter of the piston and secured in place. The mounting bar is then
          attached to the ram assembly. After adjusting the marking force to the
          required level, the operator places the part into the fixture to accurately
          position and securely hold it during the marking cycle. Depressing the dual
          palm buttons activates the marking cycle. When activated, the ram travels
          vertically downward to the part. As the leading edge of the first character
          in each line of the legend touches the part, the marking force required
          begins to develop and the leading edge is indented to the desired depth. When
          this occurs, the ram assembly traverses across the part to indent the rest of
          the legend. After the part is marked, the ram raises and the assembly slides
          back to the start position.
          
          EQUIPPED WITH:
          Indenting Ram Assembly
          Vertical Adjustment Columns
          Integrated Hydraulic Power Pack
          Operating Control Panel
          Dual Carriage Tooling
          Marking Table with V-block Fixture
          Miscellaneous Tooling, Characters
          
          *Preliminary Specifications Subject to Verification
          
          
          
          
          
          
          

Liberty Machinery Company
111 Schelter Rd Lincolnshire IL 60069-3603
Tel: 847-276-2761 Fax: 847-276-2762
Email (Request Quote): sales@libertymachinery.com
Web: www.libertymachinery.com