NEW WDM INITIAL PINCH SHEET AND PLATE BENDING ROLL
MODEL B-4-36

Specifications
Capacity rating: 10 gauge x 3’
Top Roll Diameter:4”
Dimensions: 27.5”W x 38”H x 56”L
Motor: 2 HP
Voltage:230 volt
Approximate weight: 2,235 lbs.

Features:
Heavy welded steel frame
All slides accurately machined
Rolls accurately machined from medium carbon steel
Rolls are crowned to compensate for deflection under forming load
Bearing cases machined from hardened alloy die steel
Pinch rolls adjusted by dual hand wheels via a hardened screw and hardened wedge system
Bending roll adjusted by hand wheel on end frame
Bending roll position indicated by an accurate scale pointer system
Bending roll adjusting mechanism consists of hardened steel worm and bronze worm gear running on a hardened steel screw
Rolls are driven by a unique hydraulic motor, pump, valve arrangement providing instant start, stop and reverse
Highly efficient American built hydraulic motor, pump and valves
Power transmitted from low speed high torque hydraulic motor to rolls by a heavy spur hear drive train running on sealed ball bearings
Pinch and top roll rotation powered
Roll rotation forward and reverse, controlled by dual guarded foot pedal (main motor only runs when pedal is depressed)
Industrial style safety cable switch with adjusting winch and reset button
Top roll swings forward to remove finished tube/work piece
All gear drive
Sealed ball & roller bearings on all rolls and idler gears
Unique high torque hydraulic drive system
High quality American made hydraulic components
Independent adjustment on pinch roll via a hand wheel/wedge arrangement
Alloy steel bearing cases and wedges
Bending roll adjusted with hand wheel via bronze worm gear/alloy steel screw arrangement, tiltable for cone rolling
Instant start, stop and reverse via guarded foot pedal
Safety cable on three sides of machine, front, rear and end
Swing out top roll for easy work piece removal
Starting groove in pinch roll to facilitate rapid workpiece prebending and rolling
Stainless steel scale and pointer to show bending roll position
Haze gray epoxy and safety blue enamel finish
Entire machine built in Liberty, KY using purchased parts from American or world wide suppliers

Westbrook Engineering Co Inc
23501 Mound Rd Warren MI 48091-2048
Tel: 866-FOR-SAWS Fax: 586-759-3106
Email (Request Quote): info@westbrook-eng.com
Web: www.westbrook-eng.com