Model: 5400


The Morlin 5400 Hammer speeds up and takes the work out of
the only tedious, costly, and time-consuming job of
fabricating duct work-closing the "seam." This new Morlin
tool breezes along at speeds of 15 feet per minute on
commonly used gauges. Actually, it can save half of a man's
time in making ducts, and do a better job. Ends hand
hammering! Just a couple of taps at the center
and ends a standard length duct to secure the lock ... then
the Morlin Pittsburg Lock Hammer does all the work!


* VERSATILE ...
Handles 30 to 22 Gauge (No Adjustment Required). For
straight runs, inside or outside radius ... use it in the
shop or on the job.

* PERFECT BALANCE . . .
Weight rests on the work . . . Position of handle affords
positive control and balance . . . Guides easily along seam.

* POWERFUL . . .
Heavy-duty built 115V AC motor . . . More than enough power
for any job.

* RUGGED . . .
Sturdily built for heavy-duty use . . . Ball and Roller
Bearings throughout.

Scott Machinery Inc
4700 Lang Ave, Suite D McClellan CA 95652-6215
Tel: 916-638-7718 Fax: 916-638-2450
Email (Request Quote): sales@scottmachinery.com
Web: www.scottmachinery.com