To the best of our knowledge all details listed below are deemed correct. It
          
          is the buyer's responsibility to confirm all details and we encourage an
          
          inspection of the machine(s) and accessories prior to purchase.          
          
          Equipped With:
             Hydraulically Actuated Longitudinal Table Feed
             Electromechanically Actuated Feed of Saddle
             AC Servo Vertical Drive
             Pendant Mounted and  Microprocessor Controlled Automatic Incremental
          
          Downfeed of Grinding Wheelhead from 0.00005" - 0.002" in Surface or Plunge
          
          Modes of Operation.
             Fully Automatic Grinding Cycle Including Rapid Advanced of Grinding
          
          Wheelhead, 0-7 Sparkout Passes, and Retraction of Wheelhead to a Pre-Set
          
          Distance at the Completion of the Cycle.
             Table and Saddle Guide Ways Made of Special Steel Rails with High Accuracy
          
          Steel Rollers
             Precision Needle Roller Bearings used on the Elevating Guide Ways
             Fine (Micro) Feeds Graduated to .00005" for Vertical & Cross Feeds
             Kanetsu Fine Division "LBP" Electro-Magnetic Chuck with a Pendant Mounted
          
          Potentimeter for Variable Holding Power and a Selector Switch for Automatic
          
          Demagnetization of Work Piece
             Coolant System with Paper Filtration & Magnetic Seperator
             Power "Over the Wheel" Dresser, .00025" Graduation
             Sony LH70-2 Two Axis DRO
             Yakasawa V1000 Electronic Variable Speed Drive for the Grinding Spindle
             External Hydraulic Pump and Tank
          
          General Specifications:
             Table Size:                            15-3/4" x 31-1/2"
             Grinding Capacity:                     16" x 32"
             Longitudinal Table Travel, Hydraulic:  32-5/8"
             Longitudinal Table Trabel, Manual:     33-3/8"
             Crossfeed Travel, Automatic:           16"
             Crossfeed Travel, Manual:              18"
             Spindle Center to Table:               24-3/8"
             Variable Table Speed, Hydraulic:       16 - 82 FPM
             Automatic Crossfeed Increment:         1/8" - 2"
             Crossfeed Handwheel, Per Graduation:   0.0025"
             Per Revolution:                        0.25"
             Microfeed, Per Revolution:             0.005"
             Per Graduation:                        0.00005"
             Automatics Incremental Downfeed:       0.000050" - .002"
             Auto Downfeed Dial Per Graduation:     0.0005"
             Per Revolution:                        0.05"
             Microfeed:                             0.00005" / .0001"
             Rapid Traverse Rate:                   8 IPM
             Spindle Motor:                         5 HP
             Grinding Wheel Size:                   14" x 2" x 5"
          
          Machine Dimensions:                       102" x 69" x 75"
          Machine Weight:                           6,400 lbs
          
          
          
          
          
          
          

Automatics & Machinery Co Inc
150 Martin St Longmont CO 80501-5939
Tel: 800-543-7666 Fax: 303-651-6556
Email (Request Quote): justin@automatics.com
Web: www.automatics.com