To the best of our knowledge all details listed below are deemed correct.
          It is the buyers responsibility to confirm ALL details prior to purchase.
          
          SPECIFICATIONS:
            Table Size:                         7'5" x 28'3"
            Cutting Capacity:                   6'8" x 26'8"
            Table Support Load:                 400 Lbs Sqr/Ft
            Material Support Slats:             4" x 1/8" Galvanized
            Rapid Traverse Speed:               350" IPM
            Drive System:                       Closed Loop Vector Linear Drive System
            OMAX EnduroMax Pump Horsepower:     50 HP 
            Pump Pressure:                      60,000 PSI
            Nozzle Config:                      0.016"Orifice,0.042"/4"Mixing Tube
            Garnet Feed System:                 Gravity Feed 25 lbs.
            Computer:                           PC Based w/ Monitor,Keyboard,Mouse
            Software:                           Omax Intelli-Max Control Software
            Footprint of Tank:                  340"L x 89"W x 144" H
            Weight:                             13,000 Lbs.
            Operating Weight:                   54,000 Lbs.
          
          CONTROL
            PC Based Controller 
            Windows Operating System
            USB Hub of External Hardware Additions
            Monitor with External Power Supply
            Keyboard
            Mouse
            Network Compatible
          
          SOFTWARE
            OMAX Intelli-MAX Waterjet Designed Software
            CAD/CAM Software Included with Easy to Use Drawing Library
            CAD Formats Supported for Over 50 File Types
            Heads-up Traverse Available
            No G or M Code
          
          DRIVE SYSTEM
            Closed Loop Vector Linear Drive System Designed Specifically for Waterjets by
          
          OMAX
            Electronic Gearing for Precise Cutting Control
            Dual 0.000039" (1 micron) Resolution with Linear Scale Feed Back to Control
            Motorized Z-Axis with Heads Up Traverse
          
          PUMP
            Omax EnduroMax 5060V Variable Frequency Drive High Efficiency Pump
            Variable Frequency Drive from 0 to 60,000 PSI 
            Rated for 85% Efficiency as Opposed to 60%-70% from Intensifier Pump
            Pump Hours Only Accumulate During Cutting - Not idle Time
            For Safety, High Pressure System not Pressurize Except When Cutting
            Rated for 1,000 Hours Between Pump Rebuilds
            Rebuild Pump in as little as 15 Minutes
            Very Low Pump Operating Cost
            Wired 3/60/460 Volt 
          
          EQUIPPED WITH:
            Omax EnduroMax 5060V Variable Frequency Drive High Efficiency Pump
            A-Jet 5-Axis Head Cutting up to 60 Degrees
            OMAX Intelli-MAX CAD/CAM Control & Software
            PC Based Control
            Dual SRS Variable Speed Solids Removal System with 1 Cu/yd Hoppers Each
            Laminar Sediment Filter for Drain
            600 Lbs Abrasive Hopper
            Exclusive Omax Intelli-TRAX Drive System Developed Exclusively for the
          
          Waterjet Environment 
            Parking Area for Carriage for Easy Loading from Front, Side, or Top of Table
          
          
          
          
          

Automatics & Machinery Co Inc
150 Martin St Longmont CO 80501-5939
Tel: 800-543-7666 Fax: 303-651-6556
Email (Request Quote): nick@automatics.com
Web: www.automatics.com