General Specifications As Per Brochure
           
           Max. Pressure:                           140 Bar
                                                    2000 PSI
           Coolant Volume:                          Fixed Rate System
                                                    20 Liters / Minute
                                                    5 GPM
           Tank:                                    380 Liter / 100 Gallon
           Filtration:                              Single Bag
           Outlets                                  5
           
           
           Standard Configuration:
           The ChipBLASTER J-20 is fed by a transfer pump that draws from the machine
           
           tool sump, through the filter vessel to the integral 380 liter (100 gal) tank. 
           
           When the machine tool calls for coolant, the filter pump(s) draws the coolant
           
           from the ChipBLASTER tank and pumps through the post (safety) filter to the
           
           inlet of the positive displacement pump. The coolant then flows at high
           
           pressure through a series of distribution and safety valves and on to the
           
           machine tool.
           
           M Code Requirement:
             1 "M" Code Controlled Signal is Required for Activation/Deactivation of the
           
             Chip Blaster
             2" M" Code Controlled Signals are Required to Operate the Two Outlets
             3" M" Code Controlled Signals are Required to Operate the Three Outlets
             4" M" Code Controlled Signals are Required to Operate the Four Outlets
             5" M" Code Controlled Signals are Required to Operate the Five Outlets
             A 24 VDC,110 VAC or 240 VAC Signal is Acceptable
           *Latching "M" codes are standard, If your machine uses pulsed "M" codes,
           
           please contact ChipBLASTER
           
           Required Electrical Power:
             28 amps, 230 VAC, 3 Phase, 60 Hz
             14 amps, 460 VAC, 3 Phase, 60 Hz
             18 amps, 400 VAC, 3 Phase, 50 Hz
           
           Ideal for Machine Tools Up to 10 Kw (15 HP) including Swiss
           
           See brochure for more details and options
           
           
           

Automatics & Machinery Co Inc
150 Martin St Longmont CO 80501-5939
Tel: 800-543-7666 Fax: 303-651-6556
Email (Request Quote): sue@automatics.com
Web: www.automatics.com