General Specifications per Brochure
          
          Bar Size Capacity:                         3mm (.118") - 25.4mm (1")
          Bar Length Capacity:                       12'
          Maximum Bar Length:                        12' 5"
          Minimum Bar Length:                        63"
          Magazine Capacity:                         10.7 Linear Inches
          Maximum Remnant Length:                    13"
          Operating Voltage:                         230V AC 3 Phase (400V available)
          Control Voltage:                           24 Volts DC
          Total Power Required:                      2.5 kVA/1.8 KW
          Compressed Air Required:                   90 psi, 1 cfm
          Guide Channel Oil:                         CKB100, Quantity 5 Gals. (Not
          
                                                    Incl.)
          
          Feeding Speed:                             24"/sec max. (adjustable)
          Facing Accuracy:                           +/- .020"
          Bar Change Time:                           28 seconds for 12' bar
          Bar Straightness Required:                 .007"/foot
          Bar Feeder Shipping Weight:                1700 lbs.
          Color:                                     RAL 5002 Blue, RAL 7035 Light Gray
          
          Standard Equipment Includes:
          Custom Electrical Cable Package & Interface Kit
          Remnant Retract
          Synchronization Device
          Bushing Device
          Guide Channel Set includes 1 bar pusher,
          1 nose, 1 rotating tip, 1 collet
          
          Options (prices subject to change without notice)
          
          Accessories                                                       
          
          Anti Vibration Device                                             $1,990
          Category III interface (Dual Channel Safety Circuit Protection)   $1,490
          Special adaptation kit (Required for some lathes)                 $1,990
                                                                            
          Options                                                           
          
          Additional guide channel                                          $2,000
          Spindle liner                                                     $350
          Additional collet (standard OD threaded collet) (D < 20mm)        $80
                                                                            
          Installation                                                      
          
          Installation in USA, Canada and Mexico                            $3,100
          Includes labor, travel expenses and 12 month warranty
          
          Important Notes:
          Bar Feeder installation does not include lathe-side software or hardware for
          magazine bar feeder interface. This interface must be supplied and installed
          by the lathe OEM or Distributor, prior to bar feeder installation. Maximum
          Bar diameters are for front ejection of the remnant. For remnant retraction,
          maximum diameters are slightly less. Bar straightness, proper guide channel
          selection, correct alignment and anchoring of bar feeder will ensure optimum
          performance at maximum rpm.
          
          
          

Automatics & Machinery Co Inc
150 Martin St Longmont CO 80501-5939
Tel: 800-543-7666 Fax: 303-651-6556
Email (Request Quote): sue@automatics.com
Web: www.automatics.com