Other

54" x 7.5" x 30,000 Lb LOOPCO Slitting Line

Sold by Bass Machinery·Available·Last verified 3h ago

Condition: Used

Description

54" x 7.5" x 30,000 Lb LOOPCO Slitting Line CONSISTING OF: 30,000 Lb CINCINNATI Uncoiler:\ 60" Mandrel Face 16" to 20" I.D. 72" O.D. Full Length Holddown Roll Slide Base Wichita Brake 50" Floor to Center of Mandrel Entry Unit: Peeler Table Pinch Rolls Side Guides Crop Shear Slitter Head: Drop-In Type Slitter Head, Single Eccentric Design 7.5" Dia. x 55.5" Arbor Face Slitter: Model GII 7.5x52 L Comes with (3) Sets of Shimmed Tooling and Knives Approximately 11.75" O.D. and 12.25" O.D. 100 HP DC Slitter Drive, 500 V, 850/255 RPM with Drive (TBD) Gearbox Rated at 125 HP, 3.38:1 Ratio, 1750 RPM Input, 520 RPM Output, Serv. Factor 1 13" W x 44" Dia. Spool Oscillating Scrap Winder: Rear Discharge / Dump Pit Cross Over Table Drag Board Tension Stand: 60" Face Separator Tooling Bar with Set of Separator Spacer Tooling and Discs 20,000 Lb. x 56" Recoiler: 16" I.D. with Pads for 20" 40" C/L of Mandrel to Floor 75 HP DC Motor, 500 V, 850/2000 RPM to a Turner Uni-Drive 2:1 and 1:1 Ratios and 20.93:1 Ratio to a Loopco Reducer, 650/1950 RPM Input, 31.3/93.9 Output 20,000 Lb. Coil Car: 40" Wide Deck with Extension Beyond 33" C/L of "V" to Side Mast Removed and In Storage