Other

3" x .125" RAFTER High Frequency Tube Mill Line

Sold by Bass Machinery·Available·Last verified 3h ago

Condition: Used

Description

3" x .125" RAFTER High Frequency Tube Mill Line AGE: 1992 MODEL NUMBER: RT-2000 SPECIFICATIONS: Tube Diameter: 1/2" to 3" Wall Thickness: .018" to .125" Line Speed, Max.: 400 FPM Power Supply: 480/60/3 Material: Cold Rolled, Aluminum Coated, Mild Steel Stainless Steel Yield Strength, Max.: 40,000 PSI Line Direction: Left-to-Right ENTRY SYSTEM: 10,000 Lb. KENT Double Uncoiler: Age: 1995 Model Number: SKD10000ROT95-2837 Coil I.D.: 17.5" to 20.5" Coil O.D.: 72" Coil Width, Max.: 12" Hydraulic Driven Hydraulic Unit Shear & End Welder: Strip Width, Max.: 9" On Sliding Track 12" KENT Vertical Floop: Model Number: R229E-RE Strip Width, Max.: 12" Drive Panel FORMING MILL: ABBEY ETNA Entry Guide (3) Driven Breakdown Stands with Single Point Adjustment and 2" Diameter Shafts (3) Driven Sizing Stands with Single Point Adjustment and 2" Diameter Shafts 5:1 Gearbox Ratio (3 Breakdown, 3 Fin) (6) Side Roll Stands, with Vertical Adjustment WELDING SECTION: 3-Roll Weld Box 400kW THERMATOOL High Frequency Welder: Age: 1997 Model Number: HCT400 Electrical Cabinet Supercharger Heat Exchanger Scarfing Unit Remetalizer with Hydroton Wet Filter 3-Roll Ironing Stand, Parallel Top Shaft Adjustment Squeeze Roll Cooling System COOLING SECTION: 20' Flood-Type Cooling System SIZING MILL: (3) Driven Sizing Stands with 2" Diameter Shafts and Single Point Adjustment (3) 5:1 Ratio Gearboxes (3) Side Roll Stand with Vertical Adjustment 2-Plane Turkshead CUT-OFF SYSTEM: TRU-MOTION Cut-Off: Age: 2003 Model Number: TRU-M50 Diameter, Max.: 4.125" Wall Thickness, Max.: .08" Stroke: 5" Die Set Accelerator Control Panel Single Dump Table, 2003 CHIP CONVEYOR: Belt Width: 17" Intake Height, Min.: 20" Discharge Height: 44" Length: 21' BUCKEYE DEDIMPLER: Model Number: 30-91049 Electrical Panel 2" Tooling on Machine ELEVATOR CONVEYOR: Adjustable Height Control Panel Walker Hydraulic Pump ROLL TOOLING: 2.75" Installed on Mill Approximately (22) Tooling Sizes, Customer Check Suggested: 1.475", 1.5" , 1.625", 1.725", 1.75" , 1.85" , 1.875", 1.975", 2" , 2.1" , 2.125", 2.225", 2.25" , 2.35" , 2.37" , 2.475", 2.5" , 2.6" , 2.7" , 2.75" , 2.85" , 3" CONTROL PANEL & DRIVE SYSTEM: 60 HP DC Motors Mill Control Panel MISCELLANEOUS: Mill Guarding Manuals