Forming·Bending Rolls

BUFFALO #1 HORZONTAL BENDING ROLLS

Sold by National Machinery Exchange·Available·Last verified 4h ago

Manufacturer: Buffalo
Model: #1
Condition: Used

Description

BUFFALO #1 HORZONTAL BENDING ROLLS MANUAL HEIGHT ADJUSTMENT OF UPPER ROLL MANUAL VERTICAL & LATERAL ADJUSTMENT OF GUIDE ROLLS FOUR SET OF ANGLE ROLLS MISCELANEOUS SPACE PLATES FOUR SET OD RADIOUS ROLLS 10 HP MOTOR, WIRED 3 PHASE, 60 CYCLE, 220 VOLTS FORWARD & REVERSING, CARI SPEED CONTROLLED BY DRUM SWITCH ROLLING CAPACITY: 3" X 3" X 3/8" ANGLES: LEG OUT, MINIMUM DIAMETER 24" 3-1/2" X 3-1/2" X 5/16" ANGLES: LEG OUT, MINIMUM DIAMETER 36" 2-1/2" X 2-1/2" X 3/8" ANGLES: LEG IN, MINIMUM DIAMETER 30" 3" X 3" X 5/16" ANGLES: LEG IN, MINIMUM DIAMETERS 36" SMALLEST ANGLE, LEG OUT: 1-1/2" X 1-1/2" X 3/16" MINIMUM DIMATER 13" SMALLEST ANGLE, LEG IN: 1-1/2" X 1-1/2" X 3/16" MINIMUM DIAMETER 14" FLATS ON EDGE: 3" X 5/8", MINIMUM DIAMETER 36" FLATS ON FLAT: 6" X 1", MINIMUM DIAMETER 24" ROUND BAR: 2" MINIMUM DIAMTER 24" SQUARE BAR: 1-3/4", MINIMUM DIAMETER 24"

Specifications

Angle Rolls Sets	4
Control Type	drum_switch
Direction Control	forward_reversing
Guide Roll Adjustment	manual_vertical_lateral
Max Angle Capacity Leg In (mm)	88.9
Max Angle Capacity Leg Out (mm)	76.2
Max Flat On Edge Capacity (mm)	152.4
Max Flat On Flat Capacity (mm)	254
Max Round Bar Capacity (mm)	50.8
Max Square Bar Capacity (mm)	44.45
Min Bend Diameter Angle Leg In (mm)	355.6
Min Bend Diameter Angle Leg Out (mm)	330.2
Min Bend Diameter Flat (mm)	609.6
Min Bend Diameter Round (mm)	609.6
Motor Frequency (Hz)	60
Motor Phase	3_phase
Motor Power (kW)	7.457
Motor Voltage (v)	220
Od Radius Rolls Sets	4
Upper Roll Adjustment	manual_height