0B1120 BAR LOADER/MAGAZINE TYPE,HYDRAULIC & MECHANICAL
New Iemca Genius 120 3/4" Dia X 12' - Fixed Headstock Our reference: 271996

ADDITIONAL INFORMATION on this equipment is available as a PDF. Caution: this may be large file.

GENERAL SPECIFICATIONS AS PER BROCHURE

BAR DIAMETER (ROUND): 1MM (.04") - 20 MM (.787")
BAR DIAMETER (SQ): 1MM (.04") - 14MM (.551")
BAR DIAMETER (HEX): 1MM (.04") - 17MM (29-32")
BAR LENGTH CAPACITY (MAX.): =3700MM (12')
BAR LENGTH CAPACITY (MIN.): 700MM (27.5")
MAX. REMNANT LENGTH: 400MM (15 3/4")
MAGAZINE CAPACITY: 220MM (8.7")

TOTAL POWER REQUIRED: =2Kw (7 AMPS)

OPERATING VOLTAGE: =230 VAC. 3 PHASE, 60 HZ
CONTROL VOLTAGE: =24 VDC
COMPRESSED AIR REQUIRED: 90 PSI 10CFM
MAX. FEED SPEED: =1250 MM (50") SEC MAX.ADJ.
BAR CHANGE TIME: =27 SECONDS FOR 12' BAR
OIL SPECIFICATIONS GUIDE CHANNEL: =ISO 150 QUANTITY 10 GAL.

NOT INCLUDED

COLOR: =RAL 5002 BLUE/RAL 7035 LIGHT GRAY
WEIGHT (APPROX.): =1,300 LBS
BAR STRAIGHTNESS REQUIREMENT: =.5MM/M (.007"/FT.)
=BAR STRAIGHTNESS, GUIDE CHANNEL SELECTION, AND PROPER ALIGNMENT AND
=ANCHORING OF THE BAR FEEDER WILL ENSURE MAXIMUM OPERATIONAL RPM
EQUIPPED WITH:
=AUTOMATIC LOADING MAGAZINE
=PATENTED DOUBLE PUSHER, SPACE SAVING DESIGN
=PATENTED HYDRODYNAMIC, GUIDE CHANNEL SYSTEM
USER FRIENDLY, HAND-HELD CNC CONTROL
=(1) GUIDE CHANNEL SET (SIZE TO BE CHOSEN BY CUSTOMER) L=37
=(1) O.D. BAR STOCK COLLET (TO BE CHOSEN BY CUSTOMER PER BAR DIAMETER)
(1) TELESCOPIC FRONT NOSE (MATCHES GUIDE CHANNEL SET)
AUTOMATIC REMNANT RETRACTION
SLIDING HEADSTOCK SYNCHRONIZATION DEVICE
SWISS LATHE ADAPTATION KIT
SPINDLE LINER
BAR PUSHER
ROTATING TIP
SHIPPING PALLET
ACCESSORIES:
=INSTALLATION............................................$ 2,700.00
=ADDITIONAL GUIDE CHANNEL SETS:..........................$ 2,950.00 EA
(EACH ADDITIONAL GUIDE CHANNEL SET INCLUDES (1) TELESCOPING FRONT NOSE
AND (1) SPINDLE LINER)
ADDITIONAL BAR STOCK COLLETS..............................$ 45.00 EA
= (1 NEEDED FOR EACH SIZE BAR STOCK TO BE RUN)
=ADDITIONAL SPINDLE LINER................................$ 420.00 EA
= (NEEDED WHEN USING A GUIDE CHANNEL SET BELOW THE LATHE'S BAR CAPACITY)
CAM ADAPTATION KITS FOR CAM ACTUATED SCREW MACHINES.....$ 2,250.00 EA
EJECTORS FOR FRONT REMNANT EJECTION.....................$ 55.00 EA
IMPORTANT NOTES:
=BAR FEEDER INSTALLATION DOES NOT INCLUDE LATHE-SIDE SOFTWARE OR HARDWARE
=INTERFACE. THIS INTERFACE MUST BE SUPPLIED AND INSTALLED BY THE LATHE OEM
=OR DEALER PRIOR TO BAR FEEDER INSTALLATION.
=THE ANCHORING OF THE IEMCA BAR FEEDER TO THE FLOOR IS A REQUIREMENT AND
WILL BE PERFORMED BY THE IEMCA SERVICE TECHNICIAN.

Return to Menu (Use your BACK function to return to previous screen.)